Queclink GL300 Manual page 32

GL300 @Tracker Air Interface Protocol

AT+GTFKS=
Example:
AT+GTFKS=gl300,1,,1,1,1,,,ffff$
Parameter
Password
Power key mode
Full power up
Function key mode
Power key ind
Function key ind
Reserved
Reserved
Serial number
Tail character

<Power key mode>: A numeric to indicate the working mode of the power key.
 0: Press power key will not power down the device.
 1: Press power key will power down the device.
 2: Press power key after long press for 1.5 seconds, it will work as SOS mode.

<Full power up>: A numeric to indicate whether the terminal powers on completely after the
terminal was power on because of charger inserted.
 0: Do not power on the terminal completely. And the terminal will only work on
charging.
 1: Power on the terminal completely. The terminal will work normally as power on
by power key long pressed.

<Function key mode>: The working mode for the function key operation..
 0: Ignore the function key operation.
 1: Geo-Fence mode. Switch on/off the Geo-Fence ID 0 when the function key is long
pressed. And after long press the function key, the terminal will report the message
+RESP:GTSWG to inform to switch on or off Geo-Fence ID 0 via this operation.
 2: Geo-Fence in current position. Switch on/off the Geo-Fence 0 when the function
key is long pressed and use the current position as the centre of Geo-Fence 0 when
switch on the Geo Fence 0 via the function key. After long press the function key, the
terminal will report the message +RESP:GTSWG immediately. And if this operation
is expected to switch on Geo-Fence ID 0, the terminal will start GPS fixing to get the
current position as the centre of Geo-Fence ID 0. After GPS fixing finishes, it will
report the message +RESP:GTGCR to inform the result of GPS fixing and whether
Geo-Fence ID 0 was switched on successfully.
 3: SOS mode. After long press for 3 seconds, the device will report the current
position according to the result of the latest GPS fixing and then start GPS fixing.
After the GPS fixing finishes or timeout, the device will report the SOS message
according the result of the GPS fixing.

<Power key ind>: A numeric to indicate the working mode of the motor for power key.
 0: Disable drive the motor when the power key is long pressed
TRACGL300AN001
Length (byte) Range/Format
4 – 6 '0' – '9', 'a' – 'z', 'A' – 'Z'
1 0|1|2
1 0|1
1 0|1|2|3
0 0|1
0 0|1
0
0
4 0000 – FFFF
1 $
Default
gl300
1
1
3
0
0
$
- 31 -