Initial Hardware Installation - Flashforge Creator Pro Start Up And Instruction Manual

Hide thumbs Also See for Creator Pro:

Table of Contents

FLASHFORGE 3D PRINTER

You have now finished un-boxing! The next task is to set up the hardware.

Initial Hardware Installation

Start by installing the extruder. You'll need two screws in M3×8 from Extruder's accessory kit and the

appropriate hex wrench from Tool bag found in the Foam B.

First, lower the build platform using one of the methods described in the previous section. Holding the

extruder by both sides and positions it on the extruder carriage

with the fans facing

forward. Align the

screw holes and fasten with the two screws.

Take the fan duct and M3×6 screw (the shorter one) out from Extruder accessory kit in Foam B, install the

duct onto the side cooling fan and use the M3×6 screw to fasten it.

Table of Contents

Show Quick Links

Table of Contents

Do you have a question about the Creator Pro and is the answer not in the manual?