Level Build Plate Before Initial Print - Flashforge Creator Pro Start Up And Instruction Manual

▶Start Preheating
Right Tool
Left Tool
Platform
3) Click page down key to select Left Tool (or Right Tool), Click ok key , you will see：
▶Start Preheating
Right Tool
Left Tool
Platform
4) Click page up key back to Start Preheating，and click ok key, you will see:
Heating:
R Extruder: 033C
L Extruder: 033/230C
Platform: 024
This means the left extruder is heating up, when it reaches 230℃, first push in the filament a little bit
manually until you see filament come out of the nozzle, then press the spring lever down and meanwhile
pull filament out quickly. This will ensure you have gotten rid of the filament inside the nozzle successfully.

Level Build Plate before initial print

First, make sure that you've completed below steps:
1. Your Dual Extruders should be bolted in place.
2. Your filament guide tubes connected.
3. Your spools of filament mounted on the spool holders.
4. Filament has been loaded for both extruders.
5. Check X, Y, Z end stop switch. Make sure the little metal tabs are all still there. See below pictures for
your location use.
If everything is ready, Insert the provided SD card into its slot, then flip on the power button on the back of
your Creator Pro.
OFF
OFF
OFF
OFF
ON
OFF
18
FLASHFORGE 3D PRINTER