Precautions; What's In The Box - Flashforge Creator Pro Start Up And Instruction Manual

Precautions:

[★★★ Make sure you read and understand the steps detailed in this guide]

！ The Creator Pro is very sensitive to static electricity, so make sure you contact a grounded object
before operating the machine.
 ！ Before repairing or making any alterations to the Creator Pro, it is essential that the machine is turned
off and the power cord is unplugged.
 ！ The Creator Pro operates at very high temperatures; allow the nozzle, the extruded plastic and heating
plate to cool before touching.

！ Some plastic filaments may give off a little odor when heated, because of this the machine should
always be set up in a well-ventilated area.
 ！ Do not wear gloves when operating or repairing, as entanglement may occur and cause injury.
 ！ Do not leave the machine unattended when in operation.

What's in the box?

Along with your Creator Pro 3D printer, this package contains the following:
In the foam sheet (we call it Foam A) on the top of the package, you will find:
2 filament guide tubes

2 sheets of 3M platform sticker (spare parts) and Leveling card

Below the foam sheet, you will see the Creator Pro protected by a plastic bag. On the top of the Creator Pro,
you will find extruder foam sheet (Foam B), in it you will find:
2 extruder heads

2 spool holders

4GB SD card (Contains sample models, software and latest operation manual).

Tool bag (including 2 M3×8 screws, 3 hex wrenches in different sizes, 1 spare leveling knob, 2 spare

Teflon tubes)
Extruder's accessory kit (Contains Turbo fan duct, 2 M3×8 screws, M3×6 screw)

Power cable

USB cable

Under the extruder foam sheet, you will find another foam sheet (Form C) seated in the top lid. In this foam
sheet you will find two ABS spools of filament. (Colors are randomly selected)
1
FLASHFORGE 3D PRINTER