Flashforge Creator Pro Start Up And Instruction Manual page 9
Hide thumbs
Also See for Creator Pro:
- User manual (55 pages) ,
- Quick start manual (40 pages) ,
- User manual (40 pages)
Table of Contents
Advertisement
FLASHFORGE 3D PRINTER
Next is the installation of the spool holder. Install one on each side.
The installation of the spool holder is very simple – just insert it into the rectangular opening.
Then install the filament guide tube to the empty spot on the extruder, no need to insert guide tube end
into the hole, just leave it outside, and pass the other end through buckle and buckle it.
Next is the installation of top lid. Place two anterior angles in the corresponding front slots. Slightly squeeze
the two relief angles and place them to the corresponding rear slots.
7
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Creator Pro and is the answer not in the manual?
Questions and answers