Un-Boxing - Flashforge Creator Pro Start Up And Instruction Manual

Un-boxing

The Creator Pro was carefully packed by our staff at the FlashForge factory. Please follow the un- boxing
steps laid out below.
！ Handle the package and its contents with extra care; do not use any unnecessary force.
！ Do not remove the wrapping around the nozzle. It consists of a ceramic fiber and heat- resistant tape
which helps to keep the nozzle at a constant temperature.
First, put the box on the floor in a clean and flat area. Remove the Foam A, set it aside. Inside the Foam A,
you will find 2 filament guide tubes, 2 spare platform stickers, and the leveling card.
Take the Creator Pro out from the box; Put it on your work place.
Turn the printer over and remove the protective bag from the bottom.
2
FLASHFORGE 3D PRINTER