Special Notes To Win 8, Win 8.1 And Win 10 Users - Flashforge Creator Pro Start Up And Instruction Manual

FLASHFORGE 3D PRINTER
Till now, the hardware installation is almost complete.
Next, with the power switch in the 'OFF' position, confirm that the power cord is plugged into the power
outlet next to the power switch.
Now plug the USB A to B cable into the USB B-type port, do not plug the other end in yet.
Finally install two spools of filament on the spool holders. Take a roll of ABS filament, slightly squeeze the
top of spool holder and mount the spool to the holder. Install the other side in the same way. Make sure
the filament will unwind in correct direction. I attach two diagrams to address.
Congratulations! You have completed the initial hardware installation! If you're ready to start printing,
proceed to the next step: Software Installation.

Special Notes to Win 8, Win 8.1 and Win 10 users

Win 8, Win 8.1 or Win10 users please make sure that you have disabled the Driver Signature Enforcement
setting before installing software installation; otherwise printer driver can not be installed successfully.
Below are video links showing you how to accomplish this:
Win 8.0 users: http://www.youtube.com/watch?v=NM1MN8QZhnk
Win 8.1 users: http://m.youtube.com/watch?v=gmw86KplqmU
Win 10 user: https://www.youtube.com/watch?v=71YAIw7_-kg
8