Flashforge Creator Pro Start Up And Instruction Manual page 7

FLASHFORGE 3D PRINTER
The next step is to raise the build platform; there are two ways to do this:
1) Turn the Z motor rod clockwise with your hand which is between two Z axis guide rods until there is
enough space for your hands to hold the rear of platform support.
2) Hold the platform support with one hand on each side. Important note: user must hold the rear of the
support near the Z guide rod bearings; otherwise the platform will get stuck. Raising it slowly and keeping it
level. Stop once the platform is at its highest position (about 2~3 cm lower than the X guide rods).
Remove all other packing materials out from Creator Pro. Now the machine shows you like this.
5