Flashforge Creator Pro Start Up And Instruction Manual page 21

FLASHFORGE 3D PRINTER
Lower the platform as possible as you can by turning three leveling knobs counterclockwise. In this way,
platform can avoid the initial scratch damage from nozzles.
Pay close attention: leveling your platform is very important to print quality! Creator Pro has been leveled
perfectly before leaving factory. However, it will get unleveled during long distance shipping. Please do level
the build plate again before starting the initial print.
Select LCD menu 'Print from SD → Plateleveling.x3g'. Leveling instruction scripts will shown on the LCD,
please read full scripts by click 'ok' button for next pages. After instruction, the build plate and Extruder
assembly starts moving, once they suspend, you need to adjust the corresponding leveling knob under the
right nozzle. As you adjust the knob, make sure the provided leveling card can just slides between the
nozzle and the build plate with some resistance. If the card can slide easily, you need rotate the knob
clockwise to decrease the distance. On the contrary, you need to rotate the knob counterclockwise to
increase the distance.
When you finish leveling the first point, press 'ok' button to level the next point and the third one. Finally
the extruder assembly will move to the middle of the platform and stop there. Make a final check of the
19