Installing An Mx104 Fan Tray; Figure 41: Removing The Fan Tray - Juniper MX104 Hardware Manual

Installing an MX104 Fan Tray

Copyright © 2017, Juniper Networks, Inc.
WARNING: To avoid injury, keep tools and your fingers away from the fans
as you slide the fan tray out of the chassis. The fans might still be spinning.
Place one hand under the fan tray to support it, and pull the fan tray completely out
4.
of the chassis.

Figure 41: Removing the Fan Tray

To install the fan tray (see
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Orient the fan tray in the slot so that the arrow is pointing up, and slide the fan tray
2.
straight into the chassis.
Verify that the front of the fan tray is firmly seated in the chassis.
3.
Tighten the captive screws on the fan tray faceplate to secure it in the chassis.
4.
Chapter 20: Replacing Cooling System Component
Figure 42 on page 148):
147