Mx104 Routing Engine Buttons; Mx104 Routing Engine Leds; Table 17: Mx104 Routing Engine Buttons; Table 18: Mx104 Routing Engine Leds - Juniper MX104 Hardware Manual

MX104 Routing Engine Buttons

MX104 Routing Engine LEDs

Copyright © 2017, Juniper Networks, Inc.
Each Routing Engine has two push-button controls. The buttons, labeled
and , are located directly on the faceplate of the Routing Engine.
RESET
describes the functions of the buttons.

Table 17: MX104 Routing Engine Buttons

Label Action
ONLINE Press for 2
OFFLINE seconds.
Press for 4
seconds.
Press for 3
RESET
seconds.
Each Routing Engine has three LEDs that indicate its status. The LEDs, labeled
, and , are located directly on the faceplate of the Routing Engine.
ONLINE OK/FAIL
Table 12 on page 23 describes the functions of the Routing Engine LEDs.

Table 18: MX104 Routing Engine LEDs

Label Color
Blue
MASTER
Green
ONLINE
OK/FAIL Green
Red
The management port labeled
status of the port.
NOTE: The port labeled
Table 13 on page 23 describes the LEDs in more detail.
Chapter 4: Host Subsystem Components and Descriptions
Description
Routing Engine transitions online
when pressed.
Routing Engine transitions offline
when pressed.
Routing Engine reboots when
pressed.
State Description
On steadily Routing Engine is the master.
On steadily Routing Engine is online.
Blinking Routing Engine is booting.
On steadily Routing Engine is functioning normally.
On steadily Routing Engine has failed.
has a pair of LEDs that display the speed and
ETHERNET
is not supported.
AUX
ONLINE OFFLINE
Table 11 on page 23
Indicator
Green ONLINE LED is on steadily.
All LEDs are off.
Green LED is on steadily.
ONLINE
MASTER
,
,
29