Figure 17: Gvc3202 Camera Parameters Setting Screen; Delete Preset - Grandstream Networks GVC3202 User Manual

DELETE PRESET

Access the preset editing screen, select preset and press the red shortcut key on GVC3202 remote
control to delete it.
APPLY PRESET
If you have already set preset on camera, you can apply preset via one of the following two ways:

Access camera screen and press the digital keys on the remote control to adjust camera to the preset.

Access preset screen and press the digital keys to switch to the corresponding preset, press the
yellow shortcut key to apply.
CAMERA PARAMETERS CONFIGURATIONS
Press the yellow shortcut key on GVC3202 remote control to bring out camera parameters setting screen
as shown below. Refer to the table below and configure the parameters using navigation keys on the
remote control.
Firmware Version 1.0.0.X

Figure 17: GVC3202 Camera Parameters Setting Screen

GVC3202 User Guide Page 42 of 117