Network Termination Option; Terminator And Service Switch Locations - Danfoss VLT 5000 Instruction Manual

Network The option of using termination on the
LonWorks card is provided. The option card
Termination
has a termination resistor built-in which is
Option
activated by the terminator switches. Use of
the terminator is optional, depending upon the
Terminator
T T T T T erminator Switches erminator Switches erminator Switches erminator Switches erminator Switches
and Service
Switch
Locations
MG.60.N1.22 - VLT is a registered Danfoss trademark
Switch Position Functions
T T T T T ermination ermination ermination ermination ermination
No termination
Single termination
Double termination
Free Topology LonWorks Control Card
VLT ® 5000 / VLT ® 6000
network configuration. If termination is
provided elsewhere in the network, the
termination function should be OFF.
Terminator switches position functions are
provided in the table below.
Pos 1 Pos 1 Pos 1 Pos 1 Pos 1
Net Term OFF
(Factory setting)
Net Term ON
Net Term ON
Service Pin Switch Service Pin Switch Service Pin Switch
Service Pin Switch Service Pin Switch
HVAC / VLT ® 8000 AQUA
Pos 2 Pos 2 Pos 2 Pos 2 Pos 2
Net Term OFF
(Factory setting)
Net Term OFF
Net Term ON
Service Pin Switch Service Pin Switch Service Pin Switch
Service Pin Switch Service Pin Switch
21