10. Secure
LonWorks
Card
11. Install
Ribbon
Cable on
VLT Control
Board
12. Install
LCP Cradle
16
• Secure LonWorks card with 3
self-tapping screws and washers
provided using Torx T-10 screw driver.
Tighten to 8 in-lbs (0.9 Nm).
• Be sure not to twist or crimp ribbon
cables.
• Insert cables into corresponding
sockets and fasten in accordance with
directions in step 5.
IP20/NEMA 1 and Bookstyle
• Insert cradle clips into holes in cassette.
• Push down on cradle to snap it into
place.
VLT
®
5000 / VLT
®
6000
MG.60.N1.22
HVAC / VLT
®
8000 AQUA
- VLT is a registered Danfoss trademark