Call Commands; Xcommand Call Accept; Xcommand Call Dtmfsend; Xcommand Call Disconnect - Cisco TelePresence MX700 Reference Manual

Cisco TelePresence MX700 and MX800

Introduction

Call commands

xCommand Call Accept

Accept an incoming call. If no CallId is specified, all incoming calls are accepted.
Requires user role: USER
USAGE:
xCommand Call Accept [CallId: CallId]
where
CallId: Integer (0..65534)
The CallID is returned when the xCommand Dial command is run. During the call you
can run the xStatus Call command to see the CallId.

xCommand Call DTMFSend

Send DTMF tones to the far end.
Requires user role: USER
USAGE:
xCommand Call DTMFSend [CallId: CallId] DTMFString: "DTMFString"
where
CallId: Integer (0..65534)
The CallID is returned when the xCommand Dial command is run. During the call you
can run the xStatus Call command to see the CallId.
DTMFString: String (0, 32)
Enter the DTMF string.
Cisco TelePresence MX700 and MX800 API Reference Guide CE8.0, FEBRUARY 2016.
D15335.02
About the API xConfiguration xCommand xCommand

xCommand Call Disconnect

Disconnect a call.
Requires user role: USER
USAGE:
xCommand Call Disconnect [CallId: CallId]
where
CallId: Integer (0..65534)
The CallID is returned when the xCommand Dial command is run. During the call you
can run the xStatus Call command to see the CallId.

xCommand Call FarEndControl Camera Move

Move the far end camera (the remote camera).
NOTE: The far end camera moves in the specified direction until the stop command (ref:
xCommand FarEndControl Camera Stop) is issued.
Requires user role: USER
USAGE:
xCommand Call FarEndControl Camera Move [CallId: CallId] Value:
where
CallId: Integer (0..65534)
The CallID is returned when the xCommand Dial command is run. During the call you
can run the xStatus Call command to see the CallId.
Value: Left/Right/Up/Down/ZoomIn/ZoomOut
Select the action for how to move the camera.
95
API Reference Guide
xStatus Appendices
Value
Copyright © 2016 Cisco Systems, Inc. All rights reserved.