Dos And Don'ts - Cisco TelePresence MX700 Reference Manual

Cisco TelePresence MX700 and MX800

Introduction

Dos and don'ts

Here are some best practices when programming the Cisco
MX series API.
DO use complete commands
You should always use complete commands when program-
ming, i.e. always use xConfiguration Video instead of xconf
vid. The shortcuts can be used for searches in the API on the
command line, but not for programming. The reason for this is
that you might end up with ambiguous code when additional
commands are added to the API.
DO NOT subscribe to unnecessary feedback
Subscribing to too much feedback may congest the control
application. Although the amount of feedback may seem fine
in the current version, the amount of feedback may grow in
future releases.
Cisco TelePresence MX700 and MX800 API Reference Guide CE8.0, FEBRUARY 2016.
D15335.02
About the API About the API xConfiguration xCommand
30
API Reference Guide
xStatus Appendices
Copyright © 2016 Cisco Systems, Inc. All rights reserved.