Jumper Settings; Jumper List - Winmate IH70 User Manual

Mini-itx sbc with w/ intel 4th generation core i3/i5/i7 processor, vga, lvds, dual giga ethernet, usb 3.0 and mini-pcie interface

Hide thumbs Also See for IH70:

Table of Contents

IH70 Motherboard User Manual

2.4 Jumper Settings

This section explains how to set jumpers for correct configuration of the

motherboard.

A pair of needle nose pliers may be helpful when working with jumpers.

If you have any doubts about the best hardware configuration for your

Note

application, contact your local distributor or sales representative before

you make any changes. Generally, you simply need a standard cable to

make most connections.

The jumper setting diagram is shown below. When the jumper cap is placed on both

pins, the jumper is SHORT. The illustration below shows a 3-pin jumper; pins 1 and 2

are short. If you remove the jumper cap, the jumper is OPEN.

The following table shows the function of each of the board's jumpers.

Label

JP1/JP2

JP8

JP10

JP13

JP14

Function

BKLPWR Select

Panel Power Select

VR Control/Chipset Control 1x3 header, pitch 2.0mm

PWM/DC Select

Note

1x3 Wafer, pitch 2.0mm

1x3 header, pitch 2.0mm

Table of Contents