Jumper Settings - Winmate IK70 User Manual

20 IK70 Motherboard User Manual

2.4 Jumper Settings

This section explains how to set jumpers for correct configuration of the motherboard.
Note:
A pair of needle nose pliers may be helpful when working with jumpers. If
you have any doubts about the best hardware configuration for your
application, contact your local distributor or sales representative before
you make any changes. Generally, you simply need a standard cable to
make most connections.
The jumper setting diagram is shown below. When the jumper cap is placed on both pins, the jumper is
SHORT. The illustration below shows a 3-pin jumper; pins 1 and 2 are short. If you remove the jumper cap,
the jumper is OPEN.
Caution
To avoid damaging the module, always turn off the power supply
before setting jumpers or clearing CMOS.
Jumpers
Label
JP1
JP2
JP3
JP4
CLR_CMOS
CLR_RTC
PIN 1-2 SHORT
PIN 3 OPEN
Function
Panel Power Select
Backlight Power Select
Backlight Dimming Select
Backlight Dimming Control
Select
Clear CMOS
Clear RTC
Note
2x3 header, pitch 2.0mm
1x3 header, pitch 2.0mm
1x3 header, pitch 2.0mm
1x3 header, pitch 2.0mm
1*3p P:2.0mm DIP 180o
1*3p P:2.0mm DIP 180o