Jumper Settings - Winmate IK70 User Manual

USER MANUAL

2.4 Jumper Settings

This section explains how to set jumpers for correct configuration of the motherboard.
NOTE:
A pair of needle nose pliers may be helpful when working with jumpers.
If you have any doubts about the best hardware configuration for your
application, contact your local distributor or sales representative before
you make any changes. Generally, you simply need a standard cable to
make most connections.
The jumper setting diagram is shown below. When the jumper cap is placed on both pins,
the jumper is SHORT. The illustration below shows a 3-pin jumper; pins 1 and 2 are short. If
you remove the jumper cap, the jumper is OPEN.
CAUTION
To avoid damaging the module, always turn off the power supply
before setting jumpers or clearing CMOS.
Jumpers
Label Function
JP1 Panel Power Select
JP2 Backlight Power Select
JP3 Backlight Dimming Select
Backlight Dimming Control
JP4
Select
CLR_CMOS Clear CMOS
CLR_RTC Clear RTC
All manuals and user guides at all-guides.com
CHAPTER 2
PIN 1-2 SHORT
PIN 3 OPEN
- 20 -
HARDWARE INSTALLATION
Note
2x3 header, pitch 2.0mm
1x3 header, pitch 2.0mm
1x3 header, pitch 2.0mm
1x3 header, pitch 2.0mm
1*3p P:2.0mm DIP 180o
1*3p P:2.0mm DIP 180o