Displaying And Maintaining Ipv4 Dns; Static Domain Name Resolution Configuration Example; Network Requirements - HP 3600 v2 Series Configuration Manual

Step
1. Enter system view.
2. Set the DSCP value for DNS
packets.

Displaying and maintaining IPv4 DNS

Task
Display the static IPv4 domain
name resolution table.
Display IPv4 DNS server
information.
Display DNS suffixes.
Display information about the
dynamic IPv4 domain name
cache.
Clear information about the
dynamic IPv4 domain name
cache.
Static domain name resolution configuration
example

Network requirements

As shown in
rather than an IP address.
Configure static domain name resolution on the device so that the device can use the domain name
host.com to access the host whose IP address is 10.1.1.2.
Figure 42 Network diagram
Figure 42, the device wants to access the host by using an easy-to-remember domain name
Command
system-view
dns source-interface
interface-type interface-number
Command
display ip host [ | { begin | exclude |
include } regular-expression ]
display dns server [ dynamic ] [ | { begin |
exclude | include } regular-expression ]
display dns domain [ dynamic ] [ | { begin |
exclude | include } regular-expression ]
display dns host ip [ | { begin | exclude |
include } regular-expression ]
reset dns host ip
93
Remarks
N/A
By default, no source interface for
DNS packets is specified. The
device uses the primary IP
address of the output interface of
the matching route as the source
IP address of a DNS request.
Remarks
Available in any view
Available in any view
Available in any view
Available in any view
Available in user view