HP 3600 v2 Series Configuration Manual page 224

# Reference service loopback group 1 on the tunnel.
[SwitchB-Tunnel2] service-loopback-group 1
[SwitchB-Tunnel2] quit
# Configure a static route from Switch B through interface Tunnel 2 to Group 1.
[SwitchB] ipv6 route-static 2002:1:: 64 tunnel 2
Verifying the configuration
Display the status of the tunnel interfaces on Switch A and Switch B.
[SwitchA] display ipv6 interface tunnel 1
Tunnel1 current state :UP
Line protocol current state :UP
IPv6 is enabled, link-local address is FE80::2013:1
Global unicast address(es):
3001::1:1, subnet is 3001::/64
Joined group address(es):
FF02::1:FF13:1
FF02::1:FF01:1
FF02::1:FF00:0
FF02::2
FF02::1
MTU is 1460 bytes
ND reachable time is 30000 milliseconds
ND retransmit interval is 1000 milliseconds
Hosts use stateless autoconfig for addresses
IPv6 Packet statistics:
...
[SwitchB] display ipv6 interface tunnel 2
Tunnel2 current state :UP
Line protocol current state :UP
IPv6 is enabled, link-local address is FE80::2024:1
Global unicast address(es):
3001::1:2, subnet is 3001::/64
Joined group address(es):
FF02::1:FF24:1
FF02::1:FF01:2
FF02::1:FF00:0
FF02::2
FF02::1
MTU is 1460 bytes
ND reachable time is 30000 milliseconds
ND retransmit interval is 1000 milliseconds
Hosts use stateless autoconfig for addresses
IPv6 Packet statistics:
...
# Ping the IPv6 address of the peer interface VLAN-interface 100 from Switch A.
[SwitchA] ping ipv6 2002:3::1
PING 2002:3::1 : 56
Reply from 2002:3::1
data bytes, press CTRL_C to break
213