Multicast Arp Configuration Example - HP 3600 v2 Series Configuration Manual

Figure 4 Network diagram
Configuration procedure
Configure the switch:
# Create VLAN 10.
<Switch> system-view
[Switch] vlan 10
[Switch-vlan10] quit
# Add interface Ethernet 1/0/1 to VLAN 10.
[Switch] interface Ethernet 1/0/1
[Switch-Ethernet1/0/1] port link-type trunk
[Switch-Ethernet1/0/1] port trunk permit vlan 10
[Switch-Ethernet1/0/1] quit
# Create interface VLAN-interface 10 and configure its IP address.
[Switch] interface vlan-interface 10
[Switch-vlan-interface10] ip address 192.168.1.2 24
[Switch-vlan-interface10] quit
# Configure a static ARP entry that has IP address 192.168.1.1, MAC address 00e0-fc01-0000, and
output interface Ethernet 1/0/1 in VLAN 10.
[Switch] arp static 192.168.1.1 00e0-fc01-0000 10 Ethernet 1/0/1
# Display information about static ARP entries.
[Switch] display arp static
IP Address
192.168.1.1

Multicast ARP configuration example

Network requirements
As shown in
cooperate with NLB, configure the following:
Type: S-Static
MAC Address
00e0-fc01-0000
Figure 5, a small data center uses Microsoft multicast-mode NLB. To enable the switches to
D-Dynamic A-Authorized
VLAN ID Interface
10 Eth1/0/1
8
Aging Type
N/A S