Configuring An Ipv6 Link-Local Address - HP 3600 v2 Series Configuration Manual

The preferred lifetime configured for temporary IPv6 addresses minus DESYNC_FACTOR
(which is a random number ranging 0 to 600, in seconds).
The valid lifetime of a temporary IPv6 address takes the value of the smaller of the following values:
•
The valid lifetime of the address prefix.
The valid lifetime configured for temporary IPv6 addresses.
To configure the temporary address function:
Step
1. Enter system view.
2. Configure the system to generate
and preferably use the temporary
IPv6 address of the sending
interface as the source address of
the packet to be sent.
You must also enable stateless address autoconfiguration on an interface if you need temporary IPv6
addresses to be generated on that interface. Temporary IPv6 addresses do not override public IPv6
addresses. Therefore, an interface may have multiple IPv6 addresses with the same address prefix but
different interface ID portions.
If the public IPv6 address fails to be generated on an interface because of a prefix conflict or other
reasons, no temporary IPv6 address will be generated on the interface.

Configuring an IPv6 link-local address

IPv6 link-local addresses can be configured in either of the following ways:
• Automatic generation—The device automatically generates a link-local address for an interface
according to the link-local address prefix (FE80::/10) and the link-layer address of the interface.
Manual assignment—IPv6 link-local addresses can be assigned manually.
•
An interface can have only one link-local address. To avoid link-local address conflicts, use the automatic
generation method.
Manual assignment takes precedence over automatic generation.
• If you first use automatic generation and then manual assignment, the manually assigned link-local
address will overwrite the automatically generated one.
If you first use manual assignment and then automatic generation, the automatically generated
•
link-local address will not take effect and the link-local address is still the manually assigned one. If
you delete the manually assigned address, the automatically generated link-local address is
validated.
To configure automatic generation of an IPv6 link-local address for an interface:
Step
1. Enter system view.
2. Enter interface view.
Command
system-view
ipv6 prefer temporary-address
[ valid-lifetime preferred-lifetime ]
Command
system-view
interface interface-type
interface-number
125
Remarks
N/A
By default, the system does
not generate or use a
temporary IPv6 address.
Remarks
N/A
N/A