Mitsubishi Electric Q62DAN User Manual page 80

5 UTILITY PACKAGE (GX Configurator-DA)
5 - 3
(6) Number of parameters that can be set in GX Configurator-DA
When multiple intelligent function modules are mounted, the number of
parameter setting must not exceed the following limit.
When intelligent function modules are installed to:
Q00J/Q00/Q01CPU
Q02/Q02H/Q06H/Q12H/Q25HCPU
Q02PH/Q06PH/Q12PH/Q25PHCPU
Q12PRH/Q25PRHCPU
Q00UJ/Q00U/Q01UCPU
Q02UCPU
Q03UD/Q04UDH/Q06UDH/Q10UDH/
Q13UDH/Q20UDH/Q26UDH/Q03UDE/
Q04UDEH/Q06UDEH/Q10UDEH/Q13UDEH/
Q20UDEH/Q26UDEH/Q50UDEH/Q100UDEHCPU
CPU modules other than the above
MELSECNET/H remote I/O station
For example, if multiple intelligent function modules are installed to the
MELSECNET/H remote I/O station, configure the settings in GX Configurator-DA
so that the number of parameter settings for all the intelligent function modules
does not exceed the limit of the MELSECNET/H remote I/O station.
Calculate the total number of parameter settings separately for the initial setting
and for the auto refresh setting.
The number of parameters that can be set for one module in GX Configurator-DA
is as shown below.
Target module
Q62DAN/Q62DA
Q64DAN/Q64DA
Q68DAVN/Q68DAIN/Q68DAV/Q68DAI
Example) Counting the number of parameter settings in Auto refresh setting
Maximum number of parameter settings
Initial setting
512
512
512
512
512
2048
4096
Not supported
512
Initial setting Auto refresh setting
1 (Fixed)
1 (Fixed)
1 (Fixed)
MELSEC-Q
Auto refresh setting
256
256
256
256
256
1024
2048
Not supported
256
5 (Max.)
9 (Max.)
17 (Max.)
5 - 3