Mitsubishi Electric Q62DAN User Manual page 147

7 ONLINE MODULE CHANGE
7 - 23
(c) Click the [Close] button to close the System Monitor dialog box.
(d) On the pass data dialog box of GX Configurator-DA, set the prerecorded
values and perform User range writing request. (Refer to Section 5.6.5 and
5.6.6.)
(e) Set digital values to CH
Un\G1 to 8) and turn Operating condition setting request (Y9) from off to on.
Turn on CH Output enable/disable flag (Y1, Y2) of the channel to use to
check whether proper conversion has been made or not.
(Be careful since analog outputs are provided actually.)
Digital value (buffer memory address 1 to 8:
MELSEC-Q
7 - 23