Troubleshooting (Wireless); Declaration Of Conformity - Zublin MZ5000 Operating Instructions Manual

Troubleshooting (wireless)

Fault
Detector cannot be - CP and BiDi module need to be
operated with the CP
CP beeps continuously
Devices cannot
be paired.
interrupted,
There is no sound - Transmitting block on BiDi module is activated.

Declaration of conformity

The wireless MZ 5000/BiDi module/control pad complies with the
essential requirements and relevant specifications of the European
R&TTE Directive and complies with the European
norms/specifications/standards EN60669-1 / EN60669-2-1 / EN62080
/ EMC / R&TTE / RoHS. This product is manufactured to be placed on
the market throughout Europe, including Switzerland.
Test completed at the Electronics Testing Centre in Taiwan
Wallisellen, Switzerland, 2006-09-01
Züblin
26
Cause/repair
paired (see Page 19 to 21).
- Minimum distance of 2 m
- Be aware of the dead spots, get
closer to the detector and/or select
an area with a better reception.
- Is the channel selection switch on
the bottom of the CP set to the right
channel?
- Is the time delay set to pulse?
- Are you using a free channel? If
the four-channel memory is full or
the programming process was
then the devices must be reset.
(see page 22)
- The volume on the CP
has been to "Off" (see page 14 +17)
- Check batteries in the CP
Michael