Zublin MZ5000 Operating Instructions Manual page 18

Programming button
Press the programming button for one second to switch the CP to
programming mode. You can now pair the CP with a MZ5000/BiDi
module. Assign each motion detector a channel and when pairing
ensure that the channel selection switch (1-2-3-4) on the rear of the CP
is set to the required channel and that the programming button on the
BiDi module has been activated. You can now program the CP and MZ
5000 for the next five minutes. Even if the channel is changed, the CP
remains in programming mode.
If you would like to terminate the programming mode prematurely, then
press the programming button for one second. The CP will
acknowledge termination of the programming mode with a beep.
Once a channel has been successfully programmed it cannot be
"overwritten". If an incorrect channel has been assigned, this can only
be deleted by resetting the CP:
For further details and the exact pairing/programming process are
detailed in the section"Programming/pairing the CP and BiDi
module" on page 19 to 20.
To complete a reset, press and hold the programming button for five
seconds. All of the saved channels will be deleted and the CP is
switched to programming mode.
Relay 2
OFF = relay (i.e. air conditioning etc.) switched off (for 12 hours), then
switches back to automatic mode; Auto = automatic mode; ON = relay
(light) switched on permanently (for 12 hours), then switches back to
automatic mode
Warning: when relay 2 is in pulse function, ON mode cannot be
activated!
18