Preparing For Programming/Pairing - Zublin MZ5000 Operating Instructions Manual

Motion detector

Hide thumbs

Table Of Contents

Table of Contents

Programming/pairing the CP and BiDi module

Only when both of the devices being paired (CP with BiDi module, or

BiDi module with BiDi module) are in programming mode can they

actually be paired.

Safety: The CP and the BiDi module, or the BiDi module and BiDi

module must be paired. Thanks to the encoded signal, an external

transmitter cannot operate the BiDi module or the CP.

If a channel (1-2-3-4) is assigned to a different device (CP or BiDi

module) (and vice versa), then this channel is taken and cannot be

assigned to another device. A device that has already been saved

cannot be saved on the same receiver/transmitter or BiDi module/CP

again.

Any received "codes" are automatically saved in sequence (channel 1-

2-3-4) in the memory of the relevant receiver.

If, for example, a control pad (i.e. channel 1) has already been

assigned to a BiDi module, then the CP cannot be assigned another

channel.

If a channel was accidentally (or on purpose) paired with the "wrong"

device or programming was aborted, the channel cannot be

overwritten or deleted separately. Instead, a complete reset must be

completed.

To reset, press and hold the programming button on the CP and then

the BiDi module (or if applicable, on both BiDi modules) for five

seconds. Following a successful reset, the devices will switch to the

programming mode.

Please note that all of the saved channels as well as any stored lux

values will be lost and must be reprogrammed.