Programming A Bidi Module To A Bidi Module - Zublin MZ5000 Operating Instructions Manual

6. The programming mode on the CP can be terminated prematurely
by briefly pressing the programming button.
If the programming process has not been successful, start again at
Point 1. If this still does not work, both of the devices should be reset
(press and hold the programming button for five seconds).
BiDi module/BiDi module programming process
To ensure interactivity between two motion detectors.
Connect the power supply to the motion detector.
The motion detector is ready for operation after approx. one minute
(LED on the detector is switched off after permanent On mode is
selected).
1. Press and hold the BiDi module's programming button on each of the
detectors for one second (see page 13).
The BiDi module switches to programming mode. The LED on the
detector starts to flash and the relays are switched off.
2. Consecutively initiate a detection on each of the motion detectors.
The BiDi modules then save the received code of the BiDi module that
is be paired. The LED on the detector flashes once per cycle if a
transmitter has not been stored and flashes twice per cycle if one has
been saved (flashes three times if two transmitters are stored, etc.).
Please note: The detectors remain in programming mode for five
minutes. If the detector receives a signal from a paired detector during
this process, then the light may turn on briefly. However, the
functionality of this connection is only activated in automatic operation.
Programming mode can also be terminated prematurely at the push of
a button (page 9).
If the programming process has not been successful, start again at
Point 1. If this still does not work, both of the devices should be reset
(press and hold the programming button for five seconds). As soon as
both of the BiDi modules are assigned to one another, they are
wirelessly connected in parallel. If either one of the motion detectors
notices a movement, it transfers the activation signal to the other
motion detector. To ensure the paired devices switch on, the brightness
levels must fall below the preset twilight value (lux) on the receiver.
Only detected movements are transmitted to the paired devices,
activation signals received by the CP are not transmitted. The devices
do not have a repeater function!
21