Zublin MZ5000 Operating Instructions Manual page 17

Sound selection/acoustic signals
Once a CP and detector have been paired, a different detection sound
can then be assigned to each of the detectors on the CP. The channel
selection switch on the back of the CP can be set to a channel of your
choice, this assignment works in standard operation as well as in
programming mode.
1. If you step into the coverage area of the detector and a detection
is activated, the acoustic signal will sound.
2. Briefly press the sound selection button until the
required acoustic signal sounds.
3. Once you have selected the preferred sound, initiate
another detection to ensure that the sound
is assigned to the required detector.
Test mode button
In test mode, the coverage area can be controlled and adjusted. The
LED on the motion detector flashes briefly each time a movement is
detected and the light is switched on for three seconds.
Press the relay 1 "Auto" button to terminate test mode and to switch the
motion detector back to automatic mode.
Test mode can also be manually selected directly on the detector. To
do so, turn the lux value on to the symbol of the sun and the Time 1
controller to three seconds or to test. To terminate test mode, turn the
controller back to the required position.
Acoustic volume control
Any movements that are detected are signalled acoustically on the
control pad. The volume can be adjusted by briefly pressing the button.
The following operating modes are available:
high/medium/low/beep/off.
<continued on page 18>
17