Table of Contents
Advertisement
2.2
Installing the CompactFlash or Mini PCI Module
It's better to insert the CompactFlash or mini PCI module into the socket on the SBC
first if it's necessary. After the SBC has been installed into the chassis, users need to
open the bottom cover of the chassis by loosening the 6 screws to install or replace
the CompactFlash or mini PCI module. (Figure 2.2)
Note!
The CompactFlash is allocated as a Secondary IDE Master.
Figure 2.2 Removing the bottom cover for maintenance of the CompactFlash or
2.3
Installing the 5.25" Biscuit SBC
The EBPC-5250 supports the Advantech PCM-958X series of SBCs. To install the
SBC, please remove the slim-type ODD bracket first. Then proceed as follows (Fig-
ure 2.3):
1.
Install the CPU, CPU cooler, RAM, CF or mini PCI module, etc. on the SBC.
2.
Fasten the SBC onto the chassis with the four screws provided.
3.
Connect the cables provided from the SBC to the front I/O board. (see the
detailed cable connection in Chapter 3)
4.
Connect the 12-pin power connector from the power supply to the SBC.
5.
Connect the power LED, HDD LED and power switch wire from the chassis to
the SBC.
mini PCI module
7
EBPC-5250 User Manual
Advertisement
Table of Contents
