Installing A Slim-Type Optical Disk Drive - Advantech EBPC-5250 User Manual

2.5.2

Installing a Slim-type Optical Disk Drive

The EBPC-5250 reserves space for a slim-type optical disk drive. However if it is
used, the upper PCI slot on the riser card may not be used. Please follow the installa-
tion as listed below.
1. Undo the two screws on the front plate to remove the slim-type ODD bracket
(Figure 2.7).
2. Undo the two screws to remove the front cover of the slim-type ODD.
3. Fasten the small converter board (in the accessory package of the slim-type
ODD) onto the rear of the slim-type optical disk drive by tightening the two
screws provided (See Figure 2.8).
4. Fasten the slim-type optical disk drive to the slim-type ODD bracket.
5. Put the slim-type ODD bracket in place and fasten it onto the chassis with the
two screws.
6. Connect the 40-pin IDE flat cable from the SBC. Also plug in the 4-pin power
connector from the power supply. Return the bracket to the chassis.
Figure 2.7 Install a slim-type optical disk drive into the chassis
Figure 2.8 Small converter for slim-type optical disk drive
11 EBPC-5250 User Manual