Unit Reset; Default Values - Gabarron DILIGENS DIL4GC Installation Instructions And User Manual

4.- REMOTE OPERATION USING THE WIFI G-CONTROL HUB
It is possible to control the full operation of the unit remotely with Gabarron-Elnur app or app-web. The unit must be
connected to a Wifi G-Control Hub connected to the internet to use this feature.
4.1 To associate the unit to the G-Control Hub, the
discovery mode of the hub must be activated. Press the
associate button at the back of the Gateway for 3 seconds. An
orange blinking light every second indicates association mode.
You can now control and adjust the programming and temperatures on the heater via the Gabarron-Elnur app.
4.3 To disassociate the unit, a reset of the unit must be realized. See "5. UNIT RESET". When the heater is reset, it will
remove the programming and revert back to the default settings and also disassociate from the RF network and G-Control Hub.

5.- UNIT RESET

The heater reset removes the programming and disassociates the device from the RF network if the unit was associated with a
G-Control Hub. Default values are established. To reset the unit, hold the OK/Mode and Config/Prog buttons simultaneously
for 10 seconds, the next figure will show the following to indicate the heater has been reset.
To confirm the reset of the unit, press OK/Mode button, to cancel it any other button can be pressed.

6.- DEFAULT VALUES

Operation mode
Comfort temperature
Economic temperature
Frost protection temperature
Ambient sensor Offset
RF associated
Temperature Unit
Open Window detection
Control mode
Default Programming in AUTO Mode
4.2 With the hub in discovery mode, press the Ok/Mode
button on the heater for 3 seconds until the Link symbol is
shown.
OFF
19ºC
17ºC
5ºC
0ºC
No
ºC
Disabled
PID
Economic 24h*7
17
EN