Example 2: Gain Of The Amplifier In The Metering Circuit - Aktakom ADS2061 User Manual

(12) Press the F4 button, the peak-to-peak voltage measurement will be added, finish
settings of channel 2.
Then, the period, frequency, mean and peak-to-peak voltage will be displayed at the
bottom left of the screen and change periodically (see Fig.6-1).
Example 2:
Gain of the Amplifier in the Metering Circuit
Set the probe menu attenuation coefficient as 10X and that of the switch in the probe
as 10X (see "How to Set the Probe Attenuation Coefficient" on P14).
Connect the oscilloscope CH1 channel with the circuit signal input end and the CH2
channel to the output end.
Operation Steps:
(1) Push down the Autoset button and the oscilloscope will automatically adjust the
waveforms of the two channels into the proper display state.
(2) Push down the Measure button to show the Measure menu.
(3) Press the H1 button.
(4) Press the F2 button and choose CH1.
(5) Press the F1 button and turn the M knob to choose PK-PK..
(6) Press the F2 button and choose CH2.
User Manual of Smart Digital Storage Oscilloscope
Fig.6-1 Waveform of Automation Measurement
72