Table of Contents
Advertisement
Setting
Save
Load
When the type is Image, the menu shows as following:
Save
Save and Recall the Waveform
The SDS series oscilloscope can store 15 waveforms, which can be displayed
with the current waveform at the same time. The stored waveform called out
cannot be adjusted.
In order to save the waveform of the channel CH1 into the address 1, the
operation steps should be followed:
1.
Saving: Press the H1 button， the Type menu will display at the left of screen,
turn the M knob to choose Wave for Type.
2. Press the H2 button and press F1 button to select CH1 for Source.
3.
Press the H3 button, and press the F1, turn the M knob to select 1 as object
address.
4. Press the H5 button and press F1 button to select Internal.
5.
Press the H4 button to save the waveform.
6. Recalling: Press the H3 button, and press the F1, turn the M knob to select 1
as object address. Press F2 button to set Show as ON. The waveform stored
in the address will be shown, the address number and relevant information
will be displayed at the top left of the screen.
User Manual of Smart Digital Storage Oscilloscope
Setting1
.....
The setting address
Setting8
Save the current oscilloscope setting to the
internal storage
Recall the setting from the selected address
Save the current display screen. You can
also press Copy button to do it. The file can
be only stored in a USB storage, so a USB
storage must be connected first. The file is
stored in BMP format, named according to
the current system time.
50
Advertisement
Table of Contents
