Slope Trigger - Aktakom ADS2061 User Manual

when
Mode
Holdoff

4. Slope Trigger

Slope trigger sets the oscilloscope as the positive/negative slope trigger within the
specified time.
The Slope Trigger Menu is shown as
Slope trigger menu list
MENU SETTING
Single
Slope
Mode
CH1
CH2
Source EXT
EXT/5
AC Line
slope
When
High level
Threshold Low level
Slew rate
Mode Auto
Normal
37
Polarity
Choose the polarity
Select pulse width condition and adjust the M knob
to set time.
Auto Acquire waveform even no trigger occurred
Normal Acquire waveform when trigger occurred
Single When trigger occurs, acquire one waveform then stop
Holdoff 100ns~10s, adjust M knob to set time interval before
another trigger occur.
Reset Set Holdoff time as 100ns
Fig. 5-20
Fig. 5-20 Slope trigger menu
INSTRUCTION
Set vertical channel trigger type as slope trigger.
Select CH1 as the trigger source.
Select CH2 as the trigger source.
Ext-trigger
Ext-trigger divide to 5 to extend trigger level range
AC Line as resource trigger signal.
Slope selecting
Set slope condition, turn the M knob to set slope
time.
Adjust M knob to set the
Adjust M knob to set
Slew rate=(
Acquire waveform even no trigger occurred
Acquire waveform when trigger occurred
User Manual of Smart Digital Storage Oscilloscope
.
High level
Low level lower limit.
High level- Low level)/ Settings
upper limit.