Troubleshooting - Hytera PD79X Ex Manual

expires.
Decoding:
Your radio can automatically decode the 2-Tone signaling when receiving any matched one.
During decoding, the LED glows green. After successful decoding, the LCD displays the call icon
and the call type (selective call, alert call w/voice, alert call) below the icon according the
decoding type.
If Auto Reset is enabled (by your dealer), your radio will enter the Auto Reset mode, with LED glowing
orange, until the Auto Reset Time expires. The radio cannot enter the Auto Reset mode if it is an alert call.

Troubleshooting

Phenomena
The product can not
be powered on.
During receiving
signals, the voice is
weak,
discontinuous or
totally inactive.
You can not
communicate with
other members.
Analysis
The battery may be
improperly installed.
The battery may run out.
The battery may suffer from
poor contact caused by dirtied
or damaged battery contacts.
The battery strength may be
too low.
The volume may be set to a
low level.
The antenna may get loose or
may be improperly installed.
The speaker may be blocked
or damaged.
The frequency or signaling
may be inconsistent with that
of other members.
The channel type
(digital/analog) may be set
inconsistently.
You may be too far away from
the group members.
Remove the battery and attach it again.
Recharge or replace the battery.
Clean the battery contacts. If the problem can not
be solved, contact your dealer or authorized
service center for inspection and repair.
Recharge or replace the battery.
Increase the volume.
Power off the product, and re-install the antenna.
Clean surface of the speaker. If the problem can
not be solved, contact your dealer or authorized
service center for inspection and repair.
Set your TX/RX frequency and signaling to the
same as that of other members.
Make sure all members are on the same
digital/analog channel.
Move towards other members.
Solution
47