HP 5900 Series Configuration Manual page 103

# Configure the VFs in VRRP group 1 to monitor track entry 1, and decrease their weights by 250
when the track entry transits to Negative.
[SwitchC] interface vlan-interface 2
[SwitchC-Vlan-interface2] vrrp vrid 1 weight track 1 reduced 250
4. Verify the configuration:
# Verify that Host A can ping the external network. (Details not shown.)
# Display detailed information about VRRP group 1 on Switch A.
[SwitchA-Vlan-interface2] display vrrp verbose
IPv4 Virtual Router Information:
Running Mode
Total number of virtual routers : 1
Interface Vlan-interface2
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Member IP List : 10.1.1.2 (Local, Master)
Forwarder Information: 3 Forwarders 1 Active
Config Weight
Running Weight : 255
Forwarder 01
State
Virtual MAC
Owner ID
Priority
Active
Forwarder 02
State
Virtual MAC
Owner ID
Priority
Active
Forwarder 03
State
Virtual MAC
Owner ID
Priority
Active
Forwarder Weight Track Information:
Track Object
# Display detailed information about VRRP group 1 on Switch B.
[SwitchB-Vlan-interface2] display vrrp verbose
IPv4 Virtual Router Information:
Running Mode
: Load Balance
: 1
: Up
: 120
: Yes
: None
: 10.1.1.1
10.1.1.3 (Backup)
10.1.1.4 (Backup)
: 255
: Active
: 000f-e2ff-0011 (Owner)
: 0000-5e01-1101
: 255
: local
: Listening
: 000f-e2ff-0012 (Learnt)
: 0000-5e01-1103
: 127
: 10.1.1.3
: Listening
: 000f-e2ff-0013 (Learnt)
: 0000-5e01-1105
: 127
: 10.1.1.4
: 1 State : Positive
: Load Balance
97
Adver Timer : 100
State : Master
Running Pri : 120
Delay Time : 5
Weight Reduced : 250