HP 5900 Series Configuration Manual page 61

4. Configure Device A:
# Create VLAN 1 through VLAN 200.
<DeviceA> system-view
[DeviceA] vlan 1 to 200
# Configure Ten-GigabitEthernet 1/0/1 and Ten-GigabitEthernet 1/0/2 as trunk ports, assign
them to VLANs 1 through 200, enable flush message receiving, and configure VLAN 10 and
VLAN 110 as the receive control VLANs on the ports.
[DeviceA] interface ten-gigabitethernet 1/0/1
[DeviceA-Ten-GigabitEthernet1/0/1] port link-type trunk
[DeviceA-Ten-GigabitEthernet1/0/1] port trunk permit vlan 1 to 200
[DeviceA-Ten-GigabitEthernet1/0/1] smart-link flush enable control-vlan 10 110
[DeviceA-Ten-GigabitEthernet1/0/1] quit
[DeviceA] interface ten-gigabitethernet 1/0/2
[DeviceA-Ten-GigabitEthernet1/0/2] port link-type trunk
[DeviceA-Ten-GigabitEthernet1/0/2] port trunk permit vlan 1 to 200
[DeviceA-Ten-GigabitEthernet1/0/2] smart-link flush enable control-vlan 10 110
[DeviceA-Ten-GigabitEthernet1/0/2] quit
Verifying the configuration
Use the display smart-link group command to display the smart link group configuration on a device.
# Display the smart link group configuration on Device C.
[DeviceC] display smart-link group all
Smart link group 1 information:
Device ID
Preemption mode : ROLE
Preemption delay: 1(s)
Control VLAN
Protected VLAN
Member
-----------------------------------------------------------------------------
XGE1/0/1
XGE1/0/2
Smart link group 2 information:
Device ID
Preemption mode : ROLE
Preemption delay: 1(s)
Control VLAN
Protected VLAN
Member
-----------------------------------------------------------------------------
XGE1/0/2
XGE1/0/1
: 000f-e23d-5af0
: 10
: Reference Instance 1
Role State
PRIMARY ACTIVE
SECONDARY STANDBY 1
: 000f-e23d-5af0
: 110
: Reference Instance 2
Role State
PRIMARY ACTIVE
SECONDARY STANDBY 1
Flush-count
5
Flush-count
5
55
Last-flush-time
16:45:20 2012/04/21
16:37:20 2012/04/21
Last-flush-time
16:45:20 2012/04/21
16:37:20 2012/04/21