Ipv4 Vrrp Configuration Examples; Single Vrrp Group Configuration Example - HP 5900 Series Configuration Manual

Task
Display the states of IPv6 VRRP
groups.
Display statistics for IPv6 VRRP
groups.
Clear statistics for IPv6 VRRP
groups.

IPv4 VRRP configuration examples

This section provides examples of configuring IPv4 VRRP applications on switches.

Single VRRP group configuration example

This section provides an example of configuring a single VRRP group on switches.
Network requirements
Switch A and Switch B form a VRRP group and use the virtual IP address 10.1.1.1 1 1/24 to provide gateway
service for the subnet where Host A resides, as shown in
Switch A operates as the master to forward packets from Host A to Host B. When Switch A fails, Switch
B takes over to forward packets for Host A.
Figure 26 Network diagram
Configuration procedure
1. Configure Switch A:
# Configure VLAN 2.
<SwitchA> system-view
[SwitchA] vlan 2
[SwitchA-vlan2] port ten-gigabitethernet 1/0/5
[SwitchA-vlan2] quit
[SwitchA] interface vlan-interface 2
Command
display vrrp ipv6 [ interface interface-type interface-number [ vrid
virtual-router-id ] ] [ verbose ]
display vrrp ipv6 statistics [ interface interface-type interface-number
[ vrid virtual-router-id ] ]
reset vrrp ipv6 statistics [ interface interface-type interface-number [ vrid
virtual-router-id ] ]
Figure
89
26.