HP 5900 Series Configuration Manual page 144

Figure 34 Network diagram
Switch A
Master
Vlan-int2
192.168.0.101/24
Configuration procedure
1. Create VLANs and assign ports to them. Configure the IP address of each VLAN interface as
shown in
2. Configure VRRP on Switch A:
<SwitchA> system-view
[SwitchA] interface vlan-interface 2
# Create VRRP group 1, and configure the virtual IP address 192.168.0.10 for the group.
[SwitchA-Vlan-interface2] vrrp vrid 1 virtual-ip 192.168.0.10
# Set the priority of Switch A in VRRP group 1 to 110.
[SwitchA-Vlan-interface2] vrrp vrid 1 priority 110
[SwitchA-Vlan-interface2] return
3. Configure Switch B:
# Configure the source address of BFD echo packets as 10.10.10.10.
<SwitchB> system-view
[SwitchB] bfd echo-source-ip 10.10.10.10
# Create track entry 1 to be associated with the BFD session to check whether Switch A is
reachable.
[SwitchB] track 1 bfd echo interface vlan-interface 2 remote ip 192.168.0.101 local
ip 192.168.0.102
# Create VRRP group 1, and configure the virtual IP address 192.168.0.10 for the group.
[SwitchB] interface vlan-interface 2
[SwitchB-Vlan-interface2] vrrp vrid 1 virtual-ip 192.168.0.10
# Associate VRRP group 1 with track entry 1.
Internet
Virtual router
Virtual IP address:
192.168.0.10
Figure 34. (Details not shown.)
Switch B
Backup
Vlan-int2
192.168.0.102/24
L2 switch
BFD probe packets
VRRP packets
138