F7 Parameter Settings Record - Motion Control Engineering 2000 Manual

Appendix

F7 Parameter Settings Record

Please use the following table to record your F7 menu settings. If the HC-CTL-2 board is
replaced in the future, this will provide you a quick way to re-enter proper settings. Also, if you
place a support call to MCE, these values are information you will need to speed problems solv-
ing.)
Table 7.1 F7 Parameter Log
ID# Description
1 Floor 1 (bottom floor served)
2 Floor 2 (next floor ascending)
3-
Floors in ascending order
16
Bottom Access Distance: Distance in Inches
65 from bottom floor to virtual bottom access up-
travel limit switch position.
Top Access Distance: Distance in Inches from
66 top floor to virtual top access down-travel limit
switch position.
161 Releveling distance
163 Leveling dead zone distance
191 Landing System (LS-EDGE)
208 Stepping System (Single/Dual)
209 Step Dn1
210 Step Up1
211 Step Dn2
212 Step Up2
213 Step Dn3
214 Step Up3
215 Step Dn4
216 Step Up4
217 Step Dn5
218 Step Up5
219 Step Dn6
220 Step Up6
221 Step Dn7
222 Step Up7
223 Step Dn8
224 Step Up8
225 Step Dn9
226 Step Up9
227 Step Dn10
228 Step Up10
229 Step Dn11
230 Step Up11
7-10 Manual # 42-02-1P21
Setting