Calibrating The Board - SMART kapp IQ 55 Administrator's Manual

CHAPTER 5
MAINTAINING THE BOARD
NOTE
You can use your finger or a pen to orient the board.
To orient the board when connected to a computer
1. Open SMART Settings (see Opening SMART Settings on the previous page).
2. Press Orient.
3. Press the red targets as they appear. Hold your finger or the tip of the pen at the center of
each target, and then lift the pen or finger. When you lift the pen or finger, the target moves to
the next orientation point.
IMPORTANT
Hold the pen at a right angle to the screen.
4. Continue until you've pressed all the targets.
The orientation window closes.
5. If orientation doesn't correct inaccurate touch, calibrate the board (see Calibrating the board
below).

Calibrating the board

Digital cameras in the corners of the board track the position of the pens, eraser and your finger on
the interactive surface, and then send the information to the SMART software on connected
computers, which interprets this information as mouse clicks, digital ink or an eraser in the
appropriate location. Calibration determines the position and angles of the cameras to accurately
identify the location of touches on the board.
IMPORTANT
If an error message appears while you calibrate the board, contact SMART Support
(smarttech.com/contactsupport).
To calibrate the board when connected to a computer
1. Open SMART Settings (see Opening SMART Settings on the previous page).
2. Press SMART Hardware Settings.
3. If more than one SMART product is connected to your computer, select the board.
4. Select Advanced Settings from the drop-down list.
30 smarttech.com/kb/171038