Calibrating Your Interactive Flat Panel - SMART board 8000i-G4 series Setup And Maintenance Manual

CHAPTER 6
MAINTAINING YOUR INTERACTIVE FLAT PANEL
To update firmware
1. Ensure your interactive flat panel is connected to your computer.
2. Launch the firmware updater at the following location:
Operating
system
Windows (32-bit) C:\Program Files\SMART Technologies\SMART Product Drivers\
Windows (64-bit) C:\Program Files (x86)\SMART Technologies\
3. Follow the on-screen instructions using the computer's mouse and keyboard. Don't touch the
interactive flat panel screen.
4. Select your interactive flat panel model, and then click Next.
A progress bar appears.
5. When the installation is complete, calibrate the interactive flat panel (see Calibrating your
interactive flat panel below).

Calibrating your interactive flat panel

DViT cameras in the corners of the interactive flat panel track the position of the pens, eraser and
your finger on the interactive surface, and then send the information to the SMART software, which
interprets this information as mouse clicks, digital ink or ink removal in the appropriate location.
Calibration determines the position and angles of the DViT cameras to accurately identify the
location of touches on the interactive flat panel.
IMPORTANT
If an error message appears while you are calibrating the interactive flat panel, contact
SMART Support (smarttech.com/contactsupport).
To calibrate your interactive flat panel
1. Open SMART Settings (see Opening SMART Settings on page 45).
2. Press SMART Hardware Settings.
47 smarttech.com/kb/170446
Location
SMARTFirmwareUpdater.exe
SMART Product Drivers\SMARTFirmwareUpdater.exe