Calibrating The Interactive Flat Panels - SMART Room System SRS-LYNC-XS Administrator's Manual

CHAPTER 2
MAINTAINING YOUR ROOM SYSTEM

Calibrating the interactive flat panels

Digital cameras in the corners of the interactive flat panels track the position of the pens, eraser
and your finger on the screens, and then send the information to SMART Product Drivers, which
interprets this information as mouse clicks, digital ink or ink removal in the appropriate location.
Calibration determines the position and angles of the cameras to accurately identify the location of
touches on the interactive flat panels.
Typically, you need to calibrate the interactive flat panels during initial configuration only.
However, you might need to calibrate the interactive flat panels after initial configuration in the
following situations:
Digital ink disappears as users write or draw.
l
The environment lighting changes.
l
IMPORTANT
To calibrate the interactive flat panels, you need the room system administrator account's
l
user name and password.
If your room system includes SMART Board 8055i-G5 interactive flat panels, ensure version
l
15.12.02 or later of Lync Room System software is installed before attempting to calibrate
the interactive flat panels (see Updating software and firmware on page 23).
If an error message appears while you are calibrating the interactive flat panels, contact
l
your SMART reseller or SMART Support (smarttech.com/support/entsupport).
To calibrate an interactive flat panel
1. On the console, press Options, and then press Settings.
The Enter your credentials screen appears.
2. Type the room system administrator account's user name and password in the text boxes, and
then press Authenticate.
The room system restarts.
3. Type the room system administrator account's password, and then press ENTER.
The Lync Admin Console appears.
4. Press OEM Settings, and then press SMART Settings.
SMART Settings appears.
5. Press SMART Hardware Settings.
14 smarttech.com/kb/170819