Keysight Technologies J-BERT M8020A Programming Manual page 265

Return Range
Keysight M8070A Programming Guide
Name
:N1000:CRECovery:ODRatio:AUT
O[?] on page 266
:N1000:CRECovery:RDIVider[?]
:N1000:CRECovery:RELock
:N1000:CRECovery:SOURce[?]
:N1000:EMODules:SLOT:CONNect[?]
Syntax :N1000:EMODules:SLOT:CONNect <identifier>,{ON | OFF | 1 | 0}
:N1000:EMODules:SLOT:CONNect? <identifier>
Input 'identifier': 'DCA*.SLOT*'
Parameters
ON | OFF | 1 | 0
ON | OFF | 1 | 0
Description This command enables usage of the addressed slot by M8070A. In case of
using multiple M8070A instances, make sure to enable a slot only in
exactly one M8070A instance.
This query returns the present state.
This SCPI is applicable for M8046A.
Example :N1000:EMOD:SLOT:CONN "DCA1.SLOT1",ON
This command is not the same as the similar FlexDCA command
NOTE
:EMODules:SLOT{n}:CONNect[?] {ON | OFF | 1 | 0}
The above command must be sent to FlexDCA prior starting up the
M8070A software instances that shall control FlexDCA!
Managing the slot usage and connection state must be done using the
FlexDCA commands or user interface before starting up M8070A.
SCPI Command Reference
Description under
:N1000:CRECovery:ODRatio:AUTO[?]
page 269
:N1000:CRECovery:RDIVider[?]
:N1000:CRECovery:RELock
:N1000:CRECovery:SOURce[?]
5
on
on page 269
on page 269
on page 270
265