HP 6000 SERIES Hardware Installation Manual page 37

HP Series 6000 Hardware Installation Manual
Installing the 5.25-inch Hard Disk Drive
• If
you are installing the drive into slot 1 or slot 3 (the front slots), push down
on the drive and slide it on the chassis rails toward the front of the mass
storage system chassis until the mounting tabs lock into the mounting slots
(see Figure 2-3 or Figure 2-5). Tighten the T25 bracket screw through the hole
in the front of the mass storage system chassis and into the drive bracket .
• If
you are installing the drive into slot 2 (the rear slot), push down on the
drive and slide it toward the rear of the mass storage system chassis until
the mounting tabs lock into the mounting slots (see Figure 2-4). Tighten the
bracket screw through the hole in the rear of the mass storage system chassis
into the drive bracket.
5.25·inch Hard Disk Drive Installation 2·5