Connecting The Cables - HP 6000 SERIES Hardware Installation Manual

Hardware Installation Manual
HP Series 6000
Connecting the Cables
Note
Do not alter any jumpers on the option pins that have been
installed and preset by the factory.
1.
Connect the appropriate address cable to the SCSI address cable on the drive
(see Figure 6-6). The address cables in the mass storage system are numbered
according to slot number.
2. Connect the internal SCSI cable to the drive (see Figure 6-6).
3.
If
you are installing only one CD-ROM drive, connect only one of the split
ends of the dc dual power cable to the drive (see Figure 6-6).
4.
If
you are installing two CD-ROM drives, connect each of the split ends of the
dc dual power cable to the drives.
5. Connect the long end of the dc dual power cable to any of the unused dc
power connectors on the power supply (see Figure 1-7).
6·10 CD·ROM Drive Installation