Adding A Second Cd-Rom Drive - HP 6000 SERIES Hardware Installation Manual

HP Series 6000
Hardware Installation Manual
Adding a Second CD-ROM Drive
If
you are adding a second CD-ROM drive into an existing bracket, first remove
the existing CD-ROM drive and bracket as follows:
1. Disconnect the dc power cable.
2. Disconnect the address cable from the drive.
3. Disconnect the SCSI cable.
4. Remove the T25 bracket screw from the chassis front panel, then remove the
drive and bracket from the mass storage system.
N ow add the new drive to the existing bracket:
1.
Remove the
TI0
bracket screws from the new drive and bracket you
received in the new upgrade kit.
2. Remove the new drive from the mounting bracket.
3. Install the new drive into the open slot of the mounting bracket.
4. Secure the drive in the mounting bracket with the
TIO
bracket screws (see
Figure 6-3).
If
you are installing two CD-ROM drives at the same time (from two upgrade
kits), perform the following steps:
1.
Remove the
TIO
bracket screws from one of the drives, and remove the drive
from the mounting bracket.
2. Install the drive that was just removed into the open slot of the mounting
bracket you received in the other upgrade kit.
3. Secure the drive in the mounting bracket with the
TIO
bracket screws (see
Figure 6-3).
CD·ROM Drive Installation 6·5