Mounting The Mass Storage System In A Cabinet - HP 6000 SERIES Hardware Installation Manual

HP Series 6000 Hardware Installation Manual
Mounting the Mass Storage System in a Cabinet
The mass storage system may be shipped with additional parts necessary to
install it into a 19-inch cabinet. Figure 1-8 shows the parts for installing the
mass storage system into the HP C2785A/86A cabinets. Assemble the parts as
described below.
1. First loosen several turns (but do not remove) the two screws on the front
clamp and the two screws on the rear clamp.
2. Slide the rack adapter assembly into the C2785A/86A cabinet and install the
four front screws.
Note
If
the locking tabs on the cabinet rails do not allow the rack
adapter to seat fully against the front columns, remove the
locking tab screws and move the tabs further toward the rear.
3. Slide the locking tabs on the rails in your C2785A/86A cabinet forward until
they engage into the slots in the rear of the rack adapter. Tighten the screws
while pressing forward on the locking tabs.
4. Slide the mass storage system into the rack adapter assembly until it stops.
5. Swing the front clamp up so that the four tabs of the front clamp engage into
the four slots in the front of the mass storage system, and then tighten the
two screws of the front clamp.
6. Swing the rear clamp up so that the three tabs on the top of the clamp
engage over the edge of the lip on the back of the mass storage system.
7. Attach the external front panel assembly by snapping
it
into place.
Mass Storage System '·19